EQUA-MIX INSTRUCTIONS

INSTALLATION INSTRUCTIONS

Preparation
  1. Look for grease and oil. Remove dirt and oil with a diamond-cup wheel on a grinder or chipping hammer.
  2. Examine area to be filled. It must be clean of dust and dry.

Application
  1. Remove all items from the 5-gallon can. The empty can is your mixing container.
  2. Mix Equa-Mix part “A” and part “B” in equal volumes. Hand stir for two (2) minutes or drill mix for one (1) minute Do not mix more product than can be used in 20 minutes.
  3. Paint mixed material on surface to be filled as a primer coat.
  4. Quickly add enough epoxy aggregate to the rest of the mixed epoxy to make the consistency you require. Less aggregate will help in the flow (and self-level the epoxy), but it will not change the effectiveness of the Equa-Mix.
  5. Place epoxy mix into wet, primed area and smooth with trowel.
  6. Allow to dry for 4 to 6 hours at 70℉. Equa-Mix cures slower at lower temperatures and faster at higher temperatures.

Cautions
Do not apply to wet areas or at temperatures below 50℉. Follow all safety precautions on label and MSDS sheets. Consult material safety data sheets and become thoroughly familiar with product hazards. Read the technical data sheets for more specific properties and the limits of our liability.

Note
Epoxy material cures more slowly at lower temperatures.

Equa-Mix is sold only to the express warranties contained herein. Additional warranties, express or implied, and any warranty of merchantability is hereby excluded. Buyer agrees that seller assumes no liability for consequential damages of any kind which result from the use or misuse of the merchandise sold.
Share by: